I m wondering if this post applies can i follow the instructions here and put ios on these access points.
Air cap2602e a k9 autonomous.
However all of the instruction for the cli are the same and do not tell.
Simultaneous single band or dual band 2 4 ghz 5 ghz radios integrated antennas on the 2602i access point model air cap2602i x k9 external antennas for the rugged 2602e access point model air.
For information on supported regulatory domains.
Air cap2602i a k9 convert to autonomous mode i have managed to get a static ip on the box.
Aironet 2600i access point.
Indoor challenging environments with external antennas air cap2602e x k9.
I would like to convert ap in order to register it to air wlc2112 k9.
I purchased both on ebay.
Dual band autonomous 802 11a g n air sap2602i x k95.
I returned it back and now on my second purchase e which is in a very brand new condition i have the same problem with the console access.
Cisco air cap3502i a k9 powerpc460exr processor revision c0 lwapp image version 7 5 1 53 system image file is.
I have searched for instructions on turning on flexconnect.
Air cap2602i e k9 is 2600 series wireless access point in standalone mode which offers a low cost entry level solution with no requiring wireless controller.
Now it has a combined image.
However when i go to access it from the web interface i get the following message.
Dear all i have got an air cap2702i e k9.
Ordered the wrong aps.
As per the data sheet it will work both in controller based and stand alone.
External antennas for the rugged 2602e access point model air cap2602e x k9 note the x in the model numbers represents the regulatory domain.
Air cap2602i a k9 to autonomous mode.
Access product specifications documents downloads visio stencils product images and community content.
Location not available on autonomous or standalone models.
It happened to own one air cap2602e a k9 and one air cap2602e e k9.
The ap is not in flexconnect mode.
Eco pack dual band 802 11a g n 5 quantity access points the cisco aironet 2600e access point.
Is it possible to make it work in autonomous mode.
On my first attempt to configure the first a it was not possible to access the console port.
The 2600 series access point is available in both controller based unified and standalone autonomous configurations and supports.